Hi,
I'm an Apps Engr & our SW is using Flexera for the licensing.
I'm trying top figure out how to match UMN1 & UMN2 to my customer's systems.
Based on the documentation I read so far, for Windows system, UMN1 corresponds to boot disk SN while UMN2 is the primary mac address.
However, both do not match when I check the system. I checked on my system also & same, not matching.
Is there any translation/encryption/conversion of those information before Flexera rights the info into the XML requests/response?
Looking forward to your advise...
I'm an Apps Engr & our SW is using Flexera for the licensing.
I'm trying top figure out how to match UMN1 & UMN2 to my customer's systems.
Based on the documentation I read so far, for Windows system, UMN1 corresponds to boot disk SN while UMN2 is the primary mac address.
However, both do not match when I check the system. I checked on my system also & same, not matching.
Is there any translation/encryption/conversion of those information before Flexera rights the info into the XML requests/response?
Looking forward to your advise...